19.A: Review Questions
- Page ID
- 18240
\( \newcommand{\vecs}[1]{\overset { \scriptstyle \rightharpoonup} {\mathbf{#1}} } \) \( \newcommand{\vecd}[1]{\overset{-\!-\!\rightharpoonup}{\vphantom{a}\smash {#1}}} \)\(\newcommand{\id}{\mathrm{id}}\) \( \newcommand{\Span}{\mathrm{span}}\) \( \newcommand{\kernel}{\mathrm{null}\,}\) \( \newcommand{\range}{\mathrm{range}\,}\) \( \newcommand{\RealPart}{\mathrm{Re}}\) \( \newcommand{\ImaginaryPart}{\mathrm{Im}}\) \( \newcommand{\Argument}{\mathrm{Arg}}\) \( \newcommand{\norm}[1]{\| #1 \|}\) \( \newcommand{\inner}[2]{\langle #1, #2 \rangle}\) \( \newcommand{\Span}{\mathrm{span}}\) \(\newcommand{\id}{\mathrm{id}}\) \( \newcommand{\Span}{\mathrm{span}}\) \( \newcommand{\kernel}{\mathrm{null}\,}\) \( \newcommand{\range}{\mathrm{range}\,}\) \( \newcommand{\RealPart}{\mathrm{Re}}\) \( \newcommand{\ImaginaryPart}{\mathrm{Im}}\) \( \newcommand{\Argument}{\mathrm{Arg}}\) \( \newcommand{\norm}[1]{\| #1 \|}\) \( \newcommand{\inner}[2]{\langle #1, #2 \rangle}\) \( \newcommand{\Span}{\mathrm{span}}\)\(\newcommand{\AA}{\unicode[.8,0]{x212B}}\)
Complete as directed.
Fill in the blanks:
- The floor of each workroom is maintained in a ________ and, to the extent possible, in a ________ condition.
- Hazardous conditions on walking working surfaces are ________ or ________ before an employee uses the walking-working surface again. If the correction or repair cannot be made ________, the hazard must be guarded to prevent employees from using the walking-working surface until the hazard is corrected or repaired.
- Wooden ladders are not ________ with any material that may obscure structural defects.
- No employee ________ any object or load that could cause the employee to lose ________ and fall while climbing up or down the ladder.
- Any step bolt that is bent more than 15 degrees from the ________ in any direction is removed and replaced with a step bolt that meets the requirements of this section before an employee uses it.
- The ________ ________ system is used in accordance with instructions, warnings, and design limitations set by the manufacturer or under the direction of a qualified person.
- Equipment, such as tools, ________, or buckets, is secured by a tool ________ or similar method to prevent it from falling.
- Training on fall protection systems must include:
a. ________Fall hazard recognition
b. ________Rope descent systems
c. ________Portable dock boards
d. ________Equipment hazards
e. ________Correct use and storage